Home / Mikrotik Router Configuration / Mikrotik Bandwidth Management Using the Simple Queue

Mikrotik Bandwidth Management Using the Simple Queue

Simple Bandwidth Management Mikrotik used to allocate bandwidth Mikrotik simple (simple) using Mikrotik Simple Queue menu. By using static bandwidth allocation control the bandwidth proxy for each client will continue. For instance client 1 will get the bandwidth allocation is equal 256kbps / 256kbps, as well as the client 2.

Commands that can be used are as follows:

simple queue add name = limit-1 targets-addresses = 10.10.10.10 max-limit = 256000/256000

 

simple queue add name = limit-2 targets-addresses = 10.10.10.20 max-limit = 256000/256000

Or you can also use Winbox, go to the menu Queues -> Simple Queues

Mikrotik Bandwidth Management Using the Simple Queue

Testing or monitoring of the activities of the already limited bandwidth can be viewed by using the menu torch, and the interface is the interface ether2 monitored, because the interface is connected to the local network. The command used sebegai following:

tool torch ether2 src-address = 10.10.10.0 / 24

Mikrotik Bandwidth Management Using the Simple Queue

Or  you can use Winbox, go to the Tools menu -> Torch

Mikrotik Bandwidth Management Using the Simple Queue

Thus Tutorial Mikrotiknetworking.Com about Simple Bandwidth Management Mikrotik Using Simple Queue . Please you try and adjust itself to the conditions of the network used.

May be useful 🙂

About admin

Check Also

Load Balance 2 WAN in Mikrotik

How to Load Balance 2 WAN in Mikrotik

How to Load Balance 2 WAN in Mikrotik This article again discusses Load Balancing, which …

Leave a Reply

Your email address will not be published. Required fields are marked *